© National Instruments | C-3
RMC-8356 User Manual
6. When Capacity is highlighted, press <Enter> to specify the disk capacity to configure for
RAID1.
7. Press <Enter> when Create Volume is highlighted. A warning message displays,
indicating that all data on the selected disks will be lost.
8. At the
Are you sure you want to create this volume (Y/N) prompt, press
<Y> to create the RAID volume or <N> to return to the Create Volume menu.
Recovery
Use this feature to create the recovery volume by copying data from a designated master drive
to a designated recovery drive.
Note A recovery drive is a backup drive to store data copied from the original
(master) drive. A master drive is the original drive containing the source files to be
copied to the recovery drive.
Follow these steps to create a recovery drive:
1. Select Create RAID Volume from the main menu and press <Enter>. The Create Volume
Menu screen appears.
2. Specify a name for the recovery disk drive and press <Enter>.
3. When RAID Level is highlighted, use the up and down arrow keys to select Recovery and
press <Enter>.
4. When Select Disks is highlighted, press <Enter> to select the HDD to create the recovery
volume.
5. On the Select Disks screen, use the up and down arrow keys to select a drive to use as your
master drive and press <Tab> to configure it as your master drive. Use the arrow keys to
select your recovery drive and press the space bar to configure it. Press <Enter> to complete
the disk selection.
6. When RAID Capacity is highlighted, enter your RAID volume capacity and press
<Enter>. The default setting is the maximum capacity allowed.
7. When Sync is highlighted, use the up and down arrow keys to select the Continuous or On
Request update policy. If you select Continuous, data on the master drive is copied to the
recovery drive automatically as long as both drives are connected to the system. If you
select On Request, data on the master drive is copied to the recovery drive when you
request it.
8. Press <Enter> when the Create Volume item is highlighted. A warning message displays,
indicating that all data on the selected disks will be lost.
9. At the
Are you sure you want to create this volume (Y/N) prompt, press
<Y> to create the RAID volume or <N> to return to the Create Volume menu without
making changes.
To Next Page
Loading...
Need help?
General
