Note Group 1 equipment (per CISPR 11) is any industrial, scientific, or medical equipment that does not intentionally generate radio frequency
energy for the treatment of material or inspection/analysis purposes.
Notice For EMC declarations and certifications, and additional information, refer to the Product Certifications and Declarations section.
Environmental Guidelines
Notice This model is intended for use in indoor applications only.
Notice The OEM Kit may require a heat sink or air flow to remain within the maximum allowed temperature ranges. You can mount the Thermal Kit
for CompactRIO Single Board Controller with NI-DAQmx heat spreader on the NI sbRIO model.
Notice The Development Kit must be used with the Thermal Kit for CompactRIO Single Board Controller with NI-DAQmx.
Notice The model's thermal performance is greatly influenced by several factors, including resource utilization, mounting, and adjacent power
dissipation. These factors can substantially affect the achievable external ambient temperature at which the maximum local and reported temperatures
are reached. NI recommends you validate your system to ensure local and reported temperatures remain within maximum allowed temperature ranges.
In some applications, additional thermal design may be necessary.
Notice Exercise caution when designing an enclosure for the model. Auxiliary cooling may be necessary to keep the model within the specified
operating temperature range.
Notice For information about and examples of environmental and design factors that can affect the thermal performance of NI sbRIO systems, visit
ni.com/r/sbriocooling.
Notice For model-specific guidelines about enabling proper thermal design, refer to the CompactRIO Single Board Controller with DAQmx
Hardware Installation Manual on ni.com/manuals.
Kit Identification
Kit Name Contents Part Number Environmental Notes
Development Kit
Includes the CompactRIO Single-Board
Controller plus additional accessories to
quickly access I/O and begin prototyping
a system, including the Thermal Kit for
CompactRIO Single-Board Controller
with DAQmx (787331-01).
Development Kit part
numbers end with -01.
It is acceptable to operate units from this kit in a desktop
environment without an enclosure.
OEM Kit
Includes the CompactRIO Single-Board
Controller without accessories.
OEM Kit part numbers
end with -02.
This kit should be purchased after initial system prototyping
when greater quantities are needed. It is expected to operate units
from this kit in an enclosure with a valid thermal solution. Refer
to the CompactRIO Single-Board Controller with NI-DAQmx
System Development Manual for more information about
mounting and designing a thermal solution.
Local Ambient Temperature
Local ambient temperature is the maximum temperature of the room, environment, or enclosure in which the model is installed.
Note For more information about designing a thermal solution, validating temperature, and measuring both local ambient temperature and operating
temperature, refer to the CompactRIO Single-BoardController with NI-DAQmx Hardware Installation Manual on ni.com/manuals.
Environmental Characteristics
Local ambient temperature
Development Kit -40 °C to 40 °C
OEM Kit -40 °C to 60 °C
Note (Development Kit) Local ambient temperature can exceed 40 °C if the battery case temperature is monitored and does not exceed 85 °C.
Note (OEM Kit) Local ambient temperature can exceed 60 °C if the battery case temperature is monitored and does not exceed 85 °C.
Humidity
Operating 10% RH to 90% RH, noncondensing
Storage 5% RH to 95% RH, noncondensing
Pollution Degree 2
Maximum altitude 5,000 m
sbRIO-9629 Safety, Environmental, and Regulatory Information | © National Instruments | 3
To Next Page
Loading...
Need help?
General
