How to fix a National 5600 Power Tool scraper that doesn't work under pressure?
If your National Power Tool scraper isn't working while the pump is generating pressure, it could be due to a severe blockage in the wheel drive motor hoses or defective wheel drive motors. Check the hoses for blockages and replace them if necessary. If the wheel drive motors are defective, contact the National Service Center.
What to do if the hydraulic oil is very cloudy in my National 5600 Power Tool?
If the hydraulic oil in your National Power Tool is very cloudy, it could be due to water entering the hydraulic tank, contamination with dirt, or air entering the circuit. If water has entered, repair the tank if necessary, then drain, clean the tank thoroughly, and change the oil. If the oil is contaminated with dirt, drain and thoroughly clean the tank, then change the oil. If air has entered the circuit, contact the National Service Center immediately, as excessive air can severely damage the pump. Stop the machine immediately!
Why are there oil deposits on the driving wheels of my National 5600?
If you notice oil deposits on the inner sides of the driving wheels of your National Power Tool, it could be due to worn-out shaft seals on the wheel motors or loose hose fittings. For worn shaft seals, have them replaced by a specialist. If the hose fittings are loose, tighten them. If the hose or fitting is damaged, replace it.
Why is my National 5600 Power Tool making a loud hissing noise?
If your National Power Tool machine is making an unusually loud hissing or whistling noise, it could be because fluid is passing over relief valves or there is air in the hydraulic circuit. If the noise is continuous, contact the National Service Center. If there is air in the hydraulic circuit, see Troubles 7 and 9.
What to do if the hoses are worn on my National 5600?
If your National Power Tool hoses are worn, it could be due to the hoses rubbing on components or exposure to poor environmental conditions. Replace and protect the hose if it's rubbing on components. If the hose has been exposed to poor environmental conditions, replace it and protect the equipment from such conditions.
Why does my National Power Tool have no power at 3500 rpm?
If your National Power Tool has no power with the engine running at 3500 rpm, it could be due to check valve adjustment issues or hose leaks. Contact the National Service Center immediately for assistance with check valve adjustment and hose leak checks. Do not operate the equipment in this condition!
Comprehensive rules for safe operation and equipment handling.
Qualities of a defensive operator and use of CO detectors.
Essential warnings and precautions before operating the equipment.
Identifies common issues and their remedies.
Instructions for starting, throttle control, and using hydraulic levers.
Routine checks and maintenance for hydraulic systems.
Safety data for hydraulic fluid and fire extinguisher.
General| Brand | National |
|---|---|
| Model | 5600 |
| Category | Power Tool |
| Language | English |
To Next Page
