Native Instruments O Kore 2 - Page 102

KORE 2 – 102
in reach for the host. In the case of Ableton Live, the Pages you want to
automate have to sit in slots lower than 128.
If you tend to think your VST automation from the host (choosing the
parameters in the host, and not automating by recording parameter changes
in KORE 2) the autoMation liSt can also be of help. You can organize it
in the way that suits you best, i.e. rst all CHannel PageS, and then all the
uSer PageS of the FX and the synthesis stuff last.
Use the S ound t ree to navigate the S ound M atrix and to select the different
components for accessing their Control PageS. You will notice that some
of the rows on the list are highlighted. These entries belong to the node
currently selected on the Sound tree (see chapter 3.6.1).
Use the add to autoMation liSt button below the Page liSt to add the
currently selected Page to the a utoMation l iSt . This means that all the
parameters residing on the respective Page will be accessible to the host.
Each of the added Pages shows up on the autoMation liSt.
The rst 32 rows of the autoMation liSt are reserved for the X+Y-Parameters
controlling the Sound MorPHing of the KoreSounds. You cannot move any
other Pages into this upper part of the list.
This also means that there is a maximum of 16 KoreSounds for which you
can automate the Sound MorPHing – which normally should be enough.
The left column of the a utoMation l iSt displays the name of the parameter
while the right column shows the autoMatiion id. The order of the
Automation IDs is xed, as they are dened by the VST standard.