Native Instruments O Kore 2 - Page 103

KORE 2 – 103
Editing the Automation List
The a utoMation l iSt can run in two modes; you can toggle between via the
edit autoMation liSt button. If the button is inactive, the list is read-only
and you can’t change it. For editing, toggle the button to yellow.
Pages are removed from the Automation List by selecting them and hitting
the reMoVe autoMation Page button. Please note that by removing any
Pages from the Automation List the list is not re-arranged. This provides
consistent Automation IDs for the remaining Pages and if the Performance
has been automated in a host everything is still working as before.
If you want to re-arrange the Automation List, you can either grab an entry
with the mouse and drop it at the new position in the list, or you can use
the small arrows to the right of the r eMoVe button for moving the selected
entry up or down on the list.
%
Remember that the rst
32 entries are reserved
for the Sound Morph parameters so
don’t be confused when you can’t
move the other Pages into this re-
gion of the list.