Native Instruments O Kore 2 - Page 106

KORE 2 – 106
The settings shown here can also be found on the MIDI Tab of the channel.
Please see chapter 3.4.1 for details.
The key range can be set with the mouse by clicking on the l ow /H igH n ote
values and dragging up or down.
Use the tranSPoSe parameter to transpose the channel up or down in
semitones.
The H igH /l ow V eloCity values dene the lower and upper limits of a velocity
window within which incoming MIDI notes will trigger the respective
channel. If, for example, the lower limit is set to 100, only notes with
a velocity higher or equal to 100 will trigger sound on this channel.
Furthermore, you can choose the Midi inPut port and Midi CHannel (1-16
or Omni) for the currently selected KORE 2 channel. In Omni mode the
channel receives MIDI data on all MIDI channels.
The lower-right corner of the MaPPing editor has controls to zoom in and
out of the display of the Piano roll. Click on the plus and minus symbols
to zoom in or out of the keyboard. If a higher magnication is set, you can
scroll the display with the SCroll Bar below the Piano roll.