KORE 2 – 138
3.8.3 Beat Delay
This effect unit synchronizes delay times to the internal tempo. This can
be either to an internal BPM value or to KORE 2’s Master Clock. Feedback
routing is also available, which provides cross-channel feedback and
low pass/high pass ltering. Note: The internal delay buffer has a xed
maximum size, but KORE 2’s tempo can vary over a wide range. Therefore,
the buffer may be too small to provide long delay times at very slow tempos.
If this happens, a lamp lights up to indicate a conicting setting.
Label Function Range Unit
Mix
Controls the balance between the dry, unprocessed signal (at the left) and the wet,
processed signal (at the right).
0..100 %
FX Input Switches the audio input on or off. On/Off
Tempo Sync
Switches between internal (off) and external (on) tempo synchronization. If on, KORE
2’s master tempo is used. If off, the tempo is set by the BPM parameter.
On/Off
Left Time (Numerator)
Right Time (Numerator)
Sets the number of time units by which the left and right channel is delayed, re-
spectively. The length of a time unit is controlled by [Left/Right Denominator].
1..64
To Next Page
Loading...
