KORE 2 – 169
Label Function Range Unit
Attack
Sets the time to reach maximum compression once a signal exceeds the thresh-
old level.
0.1..10 ms
Release
Sets the time for compression to cease after a signal goes below the threshold
level.
10..1000 ms
Look Ahead
Switches the Look Ahead feature on or off. This allows the compressor algorithm
to operate more precisely, but the tradeoff is a xed delay of 32 samples (under
1 millisecond at 44.1kHz).
on/off
Out Gain
Controls the overall amount of amplication applied to all bands. It is both post
compression and post-gain control.
-24..+24 dB
3.8.24 Multimode Filter
This effect provides several lter characteristics that can be blended into
each other for specic tasks. While C
utoFF
and r
eSonanCe
control the lter’s
center or cutoff frequency and its slope, the main mode can be controlled
by the t
yPe
knob, cross-fading from a low pass lter over a band pass
response to a high pass lter. Additionally, the number of P
oleS
, which
dene how rapidly the response changes past the C
utoFF
frequency, can
To Next Page
Loading...
