KORE 2 – 170
be adjusted (more poles creates a steeper response slope). Finally, you can
set the threshold at which the signal will be driven into saturation.
Label Function Range Unit
Mix
Sets the balance between the dry, unprocessed signal and the “wet” (ltered)
one.
0..100 %
Cutoff
Sets the lter’s main frequency. According to the [Type] setting all frequencies
below, around or above this frequency are passed to the output, while others are
attenuated.
25..25000 Hz
Resonance Amount
Sets the sharpness of the lter’s response peak. At higher values the lter slope
gets steeper and the cutoff frequency becomes accentuated.
0..100 %
Resonance Saturation
Level
Sets the level where overdrive saturation will start to reduce the gain. At high
resonances this particularly affects the range around the cutoff frequency. At
a low saturation level the signal is saturated early while at high values higher
signal peaks are possible.
-20..+20 dB
Type (LP-BP-HP)
Crossfades between three operation modes. At low values the effect works as
low pass, ltering all frequencies above the cutoff frequency. At high values it
becomes a high pass with inverted characteristics. In between the effect acts as
a band pass, passing only frequencies around the cutoff frequency while attenu-
ating all others.
0..100 %
To Next Page
Loading...
