Native Instruments O Kore 2 - Page 171

KORE 2 – 171
Label Function Range Unit
2-pole – 4-pole
Crossfades between a 2-pole and a 4-pole lter. The number of poles denes
the steepness of the lter cutoff slope: At low values the 2-pole setting is used
with a transition band slope of 12 dB per octave; at high values the 4-pole set-
ting provides a slope of 24 dB per octave.
0..100 %
4-pole Spread
Sets the amount of cutoff frequency spreading if the effect acts as 4-pole lter.
Internally, this mode is achieved by feeding the signal of a 2-pole lter into
another 2-pole unit. At high values the two units’ cutoff frequencies are spread
around the main cutoff. This results in a reduced resonant peak.
0..6
semi-
tones
3.8.25 Parametric EQ
The ParaMetriC eQualizer divides the frequency spectrum into four bands.
Each band’s gain can then be adjusted separately to boost or attenuate
specic parts of the sound’s frequency spectrum.
This can be useful to make a sound audible in a mix or to change the
sound’s character.
With the ParaMetriC eQ each band’s frequency can be controlled individually.
The lowest and highest bands are shelf equalizers: All frequencies below/
above the one adjusted are affected by the respective gain control. The