Native Instruments O Kore 2 - Page 186

KORE 2 – 186
whenever the loop length of the l ooP traCK wraps. You could, for example,
set up a list of l ooP t raCKS in a Midi P layer , that have different lengths
and by cycling through them you would get breaks in the downstream
sequencers.
The run button is self explanatory, as it toggles the playback of the
currently selected Track on or off.
The traCK ProgreSS Bar shows the position in the currently played track.
The displayed length of the track is always as dened by the respective
l ooP parameter of the track (see below).Beneath the P rogreSS B ar you will
nd the traCK SeleCt menu.
It is automatically populated with the currently loaded tracks and displayed
in the traCK liSt. Click on the small triangle to open the menu and choose
the desired track. When the Midi Player is running, it will switch to the
new Track. At which point this will happen depends on the setting of the
CloCKSynC menu (see below).
Apart from choosing a Track from the menu you can also use the P reViouS
traCK / next traCK buttons to move through the list of tracks.
The CloCKSynC menu has three different entries:
None means that the Player will switch to the new Track immediately,
without syncing the switch time to the global or host clock.
When Beat is selected the Player will start on the next beat of the
global or host clock.
When Bar is selected, the Player will start playback on the rst beat
of the next bar.
►
►
►