KORE 2 – 200
An active tie for a step leads to a prolongation of the tied note producing
an overlap with the following note. In combination with a portamento
sound this can be used to produce the well-known 303 acid lines. A
tied note is also indicated by a small, black arrow on the step itself.
The Play section
The run button does exactly as the name implies: It toggles playback of
the sequence on and off.
Use the trigger menu to specify if the sequencer is triggered via incoming
note messages. There are three different entries:
None means that the sequencer will commence immediately when the
Run button is activated.
Gate starts the sequencer when a note-on is received and stops it when
the note-off is received.
The CHannel SeleCt and inPut SourCe settings of the Sound dene whether
the Step Sequencer receives any MIDI data and on which MIDI channel
the data is received. Please read chapter 3.4 for details about how to use
the edit area.
When the tranSPoSe button is active the Step Sequencer transposes its
complete sequence according to the incoming MIDI notes. Please note that
►
►
►
To Next Page
Loading...
