Native Instruments O Kore 2 - Page 199

KORE 2 – 199
upper section of the markers to drag them into any position. Use this to
set up 32 steps worth of content that can be arranged on the y via the
markers.
The small dice to the left of the keyboard is the P iano r oll r andoMizer . Use
it to generate a random pattern of steps on the grid.
Below the S teP g rid you can nd an area with three additional parameters
per step: VeloCity, oCtaVe and tie. These are accessed via three tabs to the
far left of the interface.
The values are dened by clicking on the vertical columns under the Step
Grid and dragging them up or down. By clicking on the three tabs you can
switch between the three parameters:
V eloCity controls the MIDI velocity of the sequencer steps. It ranges
from 0 to 127. You can randomize the velocity for all steps by clicking
on the Velocity Randomizer (the small dice symbol).
o CtaVe transposes the octave of the sequencer up or down by one or
two octaves. Again, this can be randomized. The octave value is always
relative to the PitCH oCtaVe setting (see below).
►
►
%
Note that you can assign
the Loop Marker position
to knobs on your Kore Controller.