Native Instruments O Kore 2 - Page 211

KORE 2 – 211
These three view modes are (shown in the picture above from left to
right):
All shows the SHort naMeS of all assigned parameters for all ControlS
KnoBS and ButtonS. As soon as you touch a Control KnoB on the
hardware the P age H eader on the display shows the Long Name and
the value.
Potis is a mode that only displays the parameters assigned to the
C ontrol K noBS of your hardware. Instead of the eight B uttonS the values
of the K noBS is displayed via meters. Press a B utton on your hardware
to display the Button parameters in the Header of the display.
Single always displays the last K noB parameter you used with n aMe ,
Meter and Value. Please note, that pressing a Button on your hardware
displays the Button parameters in the Header of the display.
As a SingleSound does not only consist of u Ser P ageS but often holds a
host of Plug-in PageS, the Control Mode also offers the use of those. You
can toggle between uSer- and Plug-in PageS by hitting the Control Button
on your hardware. P lug - in P ageS work in exactly the same way as u Ser
PageS.
There is another Page type that we didn’t touch on yet: the CHannel
PageS. Of course you can only access CHannel PageS if you have focused
►
►
►
%
Plug-in Pages are not
available for Integrated
Engine KoreSounds – they only
show up when the GUI of a plug-in
is available, which is not the case
for the Integrated Engines.