Native Instruments O Kore 2

To Next Page

To Previous Page

KORE 2 – 63

Bypass removes the respective component from the signal path. This

is called Sound ByPaSS in contrast to the CHannel ByPaSS described

below.

The Open Plug-in Window command opens the interface of the

respective component. It is equivalent to a double-click. This is not

available for MultiSounds, as they can have multiple, nested plug-

ins.

Import Plug-in Presets opens a system le dialog for navigating to a

presets folder where KORE 2 saves the imported KoreSounds. KORE

2 then loads all presets of the selected plug-in and saves them. After

this batch process, all new KoreSounds are selected and Edit Mode

is opened, so you can assign any attribute to all the sounds. Click on

one

, when you are nished. By default KORE 2 offers you to create

the folder in the uSer SoundS path. Change this, if you must.

Add Extra Output is only available for plug-ins that provide several

stereo outputs: Please read your plug-in’s manual for more information

on how to address these outputs inside the plug-in. For each additional

stereo output of your plug-in, you can create a linked C

Hannel

nSert

in an adjacent channel, as seen in the illustration below. All inserts

link to the same plug-in, however you can now process each stereo

output individually. Use the CHannel inSert’s context menu to remove

the additional output again.

►

Native Instruments O Kore 2 - Page 63