Native Instruments O Kore 2 - Page 64

KORE 2 – 64
The contents of the C Hannel i nSertS can be moved around on the S ound
M atrix . Just use your mouse to drag a component to another C Hannel i nSert
anywhere on the Sound Matrix. You can:
Replace the existing component by dropping the moved one directly on
the CHannel inSert. The target-insert is depicted with a yellow bar.
Insert the moved component between or above the already populated
CHannel inSertS by dropping it on the dividing line between the Inserts.
The target spot is displayed with two yellow lines.
The same applies to changing channel positions, except that you can’t
replace existing ones. Take a channel by its CHannel Header and move it to
its new place in the Sound Matrix. Again, the target is depicted by yellow
lines. Rename channels by double-clicking their C Hannel H eader and type
in a new name via the keyboard of your computer. The C Hannel n uMBer
shown on the CHannel Header, also mirrors the function of the CHannel
on/oFF switch on the audio taB (see below). Click it and it will bypass the
complete channel. A bypassed channel is depicted with a yellow cross in
its header.
►
►