KORE 2 – 70
The Audio Tab
The Audio and MIDI tabs of the Sound Matrix.
The rst element of the Audio Tab is the C
Hannel
o
n
/o
FF
switch. Use it
to deactivate audio processing for the Channel. This will also take the
respective load from your CPU.
The Solo button switches the channel to solo mode. This mutes all
other channels, so only the soloed channel is audible.The M
ute
button
silences the channel. Please be aware, that signal processing still
affects a muted channel and will put the same load on your CPU as
if not muted. To the right you find the inPut gain knob for leveling
out incoming signals. It ranges from -40 dB to 40 dB and comes in
very handy for avoiding clippings inside of your sound structures.
The current level of the input signal is displayed by the inPut leVel Meter
and you can choose the inPut SourCe via a dedicated menu below.
To Next Page
Loading...
