Native Instruments O Kore 2 - 3.5.3 Creating Pages and assigning controls

KORE 2 – 88
3.5.3 Creating Pages and assigning controls
The only Page type you can create from scratch is the u Ser P age . Of course
you are also free to change any existing uSer PageS to t your needs.
To create a new u Ser P age you must rst decide on which level of your
Sound Matrix you want to create it. Remember that you can have uSer PageS
for every component, be it a SingleSound containing a VST/AU-plug-in or
an internal Effect Component, a MultiSound or a Performance. Create the
Page by clicking the new Page icon beside the Page SeleCt menu
Once you have created a uSer Page you are ready to populate it by
assigning parameters to the Controls of the Page. This is a straightforward
process:
Click on the Controller you want to assign the parameter to (or touch it
on your KORE 2 Controller). It starts to blink in red within the software
and glows on the hardware.
Click on the l earn button on the a SSign or d iSPlay Tab of the Controller.
The l earn button as well as the selected Controller starts to blink. The
respective control of the hardware does the same.
Move the parameter you want to assign. It can sit anywhere in KORE 2.
A knob on a plug-in interface, a mixer parameter, anything goes.
Hit the learn button again to exit learn mode or continue assigning
►
►
►
►