2.2 Option 2: Restore
!
# If you wish to revert to the jog wheel calibration settings applied in the factory click
Restore in the calibration dialog shown below.
" A window is displayed to confirm that the factory calibration settings of the jog wheel
were successfully restored.
# Click OK to return to the Preferences window. The same procedure can be used to re!
store the factory settings of the right jog wheel by selecting Recalibrate Right in the S4 con!
troller preferences and following the instructions above.
2.3
Jog Wheel Calibration Failure
!
If the jog wheel is not pressed correctly at any point during the calibration a failure mes!
sage will appear (see Image below) indicating the recalibration has failed. Click OK to re!
turn to the Preferences window. This will also restore the calibration settings the wheel
had before starting the recalibration procedure. To start again click Calibrate Left and follow
the steps described above, ensuring you press at the appropriate location on the jog wheel
without using excessive pressure.
Calibration in Traktor
Option 2: Restore
TRAKTOR KONTROL S4 - Jog Wheel Calibration Guide - 12
To Next Page
Loading...
