What to do if Natus Measuring Instruments has a missing or bad signal?
If you're experiencing a missing or bad signal with your Natus Measuring Instruments, try swapping cables to the Breakout Box. You can also run a channel test to diagnose the issue.
How to run a channel test on Natus Measuring Instruments?
To run a channel test on Natus Measuring Instruments: 1. Set the LFF to 0.1 Hz on the montage settings toolbar. 2. Go to Controls->Channel Test. 3. Click Sine or Square in the first menu on the Channel Test control bar. 4. Adjust the waveform frequency and amplitude on the Channel Test control bar as needed.
General| Brand | natus |
|---|---|
| Model | neuro Embla Dx Series |
| Category | Measuring Instruments |
| Language | English |
Details specific safety and EMC standards the system adheres to.
Lists conditions where the amplifiers should NOT be used.
Provides general warnings about system use and data storage.
Warnings related to electrical connections and safety.
Warnings related to the patient's environment and proximity.
Guide to configuring the network IP address for the system.
A checklist to help diagnose and resolve common issues.
To Next Page
