Need help?Do you have a question about the natus OLYMPIC STERILE-DRIER 44 and is the answer not in the manual?
General| Brand | natus |
|---|---|
| Model | OLYMPIC STERILE-DRIER 44 |
| Category | Laboratory Equipment |
| Language | English |
Provides instructions and requirements for installing the Drier unit.
Outlines the electrical configurations and power needs for the Driers.
Guides through the steps for assembling the Drier, including cleaning.
Explains the procedure for securely anchoring the Drier to the floor.
Details the procedure to test the Drier's proper operation after installation.
General instructions for operating the Olympic Drier.
Guidance on loading parts and tubes into the Drier for drying.
Steps for drying individual parts using the Drier's trays.
Details on using the thermostat to set the internal drying temperature.
Instructions for setting the operating duration using the timer control.
Instructions on how to replace the HEPA filter in the Drier.
Lists common problems, probable causes, and suggested solutions.
Step-by-step instructions for replacing the main and transformer fuses.
Procedure for replacing the heater if it is not functioning correctly.
Instructions for replacing the control panel printed circuit board (PCB).
Steps for replacing the blower assembly or its motor.
Procedure to test the thermal cut-out function annually.
Details electrical power requirements, voltage, and fuse specifications.
To Next Page
