4 | Preface
5.2 Simrad GB40 using SimNet heading sensor ............................................... 32
5.3 Northstar 8000i / Simrad GB40 using a NMEA 0183 heading sensor.............. 33
5.4 Setup the radar with the GB40 or 8000i.................................................... 35
6 Connect Simrad NX40 / NX45, Northstar M84 / M121 .............................. 38
6.1 Parts needed NX40/45 and M84/M121...................................................... 38
6.2 Simrad NX40/45 Northstar M84/M121 radar connections ............................ 39
6.3 Set up the radar with the Simrad NX40/45 or Northstar M84/M121 .............. 41
7 Connect Northstar 6000i / 6100i ............................................................... 42
7.1 Parts needed to connect to a Northstar 6000i / 6100i ................................. 42
7.2 Connect the radar processor to a 6000i or 6100i display ............................. 43
7.3 Connect the radar communications cable (NS003107) to the junction box ..... 44
7.4 Configure the remote power control for a 6000i or 6100i (common power
source) ............................................................................................... 46
7.5 Configure the remote power control for a 6000i or 6100i (different power
sources).............................................................................................. 47
7.6 Set up the radar with the Northstar 6000i or 6100i .................................... 49
7.7 Turn the radar on and off ....................................................................... 49
7.8 Configure the navigator communications .................................................. 50
7.9 Adjust the appearance settings ............................................................... 50
7.10 Heading sensor requirements ................................................................ 51
7.11 Disable the heading sensor input ........................................................... 51
7.12 Calibrating the radar ............................................................................ 51
7.13 Prepare for calibration .......................................................................... 51
7.14 Tune the radar .................................................................................... 52
7.15 Set the STC Curve ............................................................................... 52
7.16 Set the trigger delay ............................................................................ 52
7.17 Set the heading calibration (heading sensor installed)............................... 53
7.18 Set the heading calibration (heading sensor not installed) ......................... 54
7.19 Restore all the factory settings .............................................................. 54
7.20 Restore the factory appearance settings ................................................. 54
7.21 Manual tuning procedure for the 6000i or 6100i system ............................ 55
8 Connect to Lowrance Displays ................................................................... 56
8.1 Parts needed to connect to Lowrance displays ........................................... 56
8.2 Lowrance displays radar connection ......................................................... 58
8.3 Set up the radar with Lowrance displays ................................................... 60
9 Maintenance .............................................................................................. 66
9.1 General maintenance ............................................................................. 66
9.2 Scanner maintenance ............................................................................ 66
9.3 Other maintenance items ....................................................................... 66
To Next Page
Loading...
Need help?
General
