NF9128 MOVEMENT INSTRUCTION
A . Brief Introduction of Functions
15-unit timing function, displaying hour, minute, second, year (from 2000 to 2099), month and week.
In the Local Time Mode, there is an animated display in every 10 seconds.
Time of 24 major cities in the world.
Three sets of alarm and hourly chime function
12- /24-hour time format selection and fully-automatic calendar
1/100s chronograph and split time function (L-00~L-99)
20 sets of LAP memories could be stored / inquired (from L01 to L019 and the last set of memory.)
Countdown Function(the maximum value could be 23 hours 59 minutes 59 seconds; auto repeat
function; 30 seconds of alarm signal reminder at the end of countdown
）
5 seconds of fading EL backlight
In any setting mode, hold C or D buttons for a few seconds to enter quick adjustment function
In any setting mode, it would automatically go back to time display mode if without any operation for 1
minute.
B . Function Modes
1. In any mode, press A to turn on EL backlight for 3 seconds.
Press C to deactivate or activate Summer Time; after Summer Time is activated, the signal (“DST”)
would be seen in the display. Summer Time “DST” refers to a time which is 1 hour earlier than the
standard time, and please note that not all the countries or regions use Summer Time.
In Local Time Mode, press D to deactivate or activate hourly chime function, with the signal (“CHI”).
Press A for two seconds to enter time setting state
a). At this moment, “12- /24-hour time format” flashes, and press Button B to select the following items
in turns:
To Next Page
Need help?
General
