Why Navitel RD5 Receiver car radio doesn't turn on?
If your Navitel Receiver car radio doesn't turn on, it could be due to a few reasons. First, check the connection of the yellow and red wires. Second, verify the black wire connection to the ground. Finally, a blown fuse could also be the culprit, in which case you should replace it.
What to do if Navitel Receiver has no sound?
If there is no sound from your Navitel Receiver, it may be due to misconnected loudspeaker wires, so check their connection. Another potential cause is bare loudspeaker wires touching each other or the chassis ground. Make sure to insulate all bare speaker wires from each other and the chassis ground.
What causes a blown fuse in Navitel RD5 Receiver?
A blown fuse in your Navitel Receiver can be caused by several issues. The yellow and/or red wires might be in contact with the chassis ground, so insulate them and replace the fuse. Alternatively, loudspeaker wires could be in contact with the chassis ground; insulate these wires and replace the fuse. Finally, using the wrong fuse rating can also cause it to blow, so use the fuse with the correct rating.
To Next Page
General