07
Before Start
Before start
Make sure the drain pipe is tightly connected.
Minor leakage may occur during installation or during an accident
cycle. This is not the result of a malfunction or mechanical failure,
but rather the residual water left over from the product when it is
tested for ex-factory performance.
Connect the water inlet hose and turn on the tap.
Check whether there is leakage around the hose and the inlet hose
connector.
Plug in the power cord.
Attention
If the power cord is damaged, to avoid danger, it must be replaced by
a licensed electrician.
The maximum weight of dry textile materials used in the washing
machine is 3.0kg, and the drying rate is 1kg. The quick washing
procedure recommends washing a small amount of clothes below
1kg.
If chemicals are used to clean clothes, the drying function cannot be
used.
Cotton waste is not allowed to pile up around the machine.
Adequate ventilation must be provided when machine is installed in
a cabinet or a closed space
This washing machine is only for cold water washing. Do not connect
the inlet pipe to the hot water tap.
Check the grounding to prevent electric shock.
08
Before Start
Door
Do not open during
operation
Control panel
Power cord
Water tap
Please turn off the tap after the
washing cycle is completed
Note: please refer to the installation guide for product accessories.
Max. inlet water pressure: 1.0MPa.
Min. inlet water pressure, if necessary: 0.03MPa.
To Next Page
