1-14 Introduction
Loading Configuration Settings
To load the configuration settings from a configuration (.cfg) file to the application,
follow these steps:
1.
Select Load Configuration File.
The application displays the Open window.
2.
Locate the configuration file and select Open.
The application loads the printer settings from the configuration file to the
application tabs.
Resetting All Parameters to Default
Configuration Utility parameters can be reset one tab at a time. To reset all parameters
on the active tab to default, follow these steps:
1. Select a printer setting tab.
2.
Select Default Setting.
The application sets all data on the active tab to default settings, which are marked
with an asterisk (*).
Example: When the Emulation tab is active and the Default Setting button is selected,
only the Emulation tab data are reset to default values. Data on other tabs or actual
printer settings are not affected.
To Previous Page
Loading...