NCR 7360-K071 - Page 16

To Next Page

To Previous Page

Standard Tri–Light/Lane Light Assembly with Lane Light

Label (Self Checkout)

4. Insert the Tri–Light/Lane Light cable through the opening in the side of Tri–

Light/Lane Light pole and route it out the top of the pole.

Note: For the Tri–Light/Lane Light assembly without a camera, only the Tri–

Light/Lane Light cable extender exist in the assembly.

Tri–Light Destination Connection (Location)

Tri–Light/Lane Light cable extender I/O Box (Tri–Light/Lane Light port)

Ethernet (LAN) cable extender Ethernet (LAN)

I/OBox (Power) cable extender I/OBox (Input Belt)

Tip: To make routing the cable extender through the pole easier, first attach a

weight (for example, a large bolt) to a long piece of string and drop the weighted

end of the string through the Tri–Light/Lane Light pole. Once the string is threaded

through the pole, tie the non-weighted end of the string around the cable connector

and then pull the cable extender through the pole.

Note: If installing a secondary display, route the display cables out of the smaller

hole on the back of the pole.