9-100 2x20 Customer Display Interface
Move Cursor To Specified Position
Format
1B 13
Range
00 ≤ nn ≤ 27
(hex)
Description
Moves the cursor to the specified position. Position 0 is the upper leftmost position, and
position 27 is the lower rightmost position. Any value outside this range is discarded,
the command is ignored, and the cursor is moved. The cursor location always indicates
the position of the next character to be displayed, whether the cursor is enabled and
blinking or not. After each character is displayed, the firmware performs a logical Move
Cursor Right command. The character positions are shown in the following:
To Next Page
Loading...