Hardware Installation 2-25
b. Connect the peripheral cables to their assigned ports.
• For Transaction Printer, refer to Connecting the Transaction Printer on page27
• For Cash Drawer, refer to Connecting the Cash Drawer on page28
6. Connect the LANCable to the LANconnector on the terminal.
7. Connect the Power Adapter Cable to the DC Power connector on the terminal.
Caution: The NCR 7613 requires the NCR 24 V power supply that is shipped with
the terminal. Use of other power bricks may cause damage to the unit.
8. Close the IO Panel Cover, and then carefully place the terminal upright on its feet.
Note: Make sure that all cables are correctly routed and are not pinched.
9. Remove the Touchscreen Protective Film from the Resistive or PCAP Touchscreen.
Note: The PCAP Touchscreen functions with the protective film in place, but for
best results, remove the protective film.
10. Tilt the Display Head back to its original position.
11. Connect the AC Power Cord to the Power Supply and to an ACoutlet.
Caution: Do not connect or disconnect the 24V Power Adapter Cable from the
terminal with the AC Power Cord connected to an AC outlet.
To Next Page
Loading...