To Next PageTo Next Page
Need help?Do you have a question about the NDS Dometic PSB12-40 and is the answer not in the manual?
General| Input Frequency | 50/60 Hz |
|---|---|
| Output Current | 40 A |
| Operating Temperature | -20°C to +50°C |
| Battery Type Compatibility | Lead Acid, GEL, AGM, Lithium |
| Charging Stages | Bulk, Absorption, Float |
| Protection Features | Overvoltage, Overcurrent, Short-circuit, Reverse polarity |
| Cooling | Temperature controlled fan |
Instructions for safely installing the device, including hazard warnings.
Guidelines for safe operation of the device, covering hazards and conditions.
Precautions for handling batteries, including risks of injury, health, electrocution, explosion, and damage.
Specific safety advice for handling lithium batteries, covering risks and damage prevention.
Safety advice for handling lead acid batteries, including health and damage hazards.
Overview of the charger's capabilities, charging current, and features.
Details on connections and controls, including designations and functions.
Explanation of the main charging cycle and IUOU characteristics.
Details on the analysis phase for deeply discharged batteries.
Description of the bulk charging phase, including current and voltage details.
Explanation of the absorption phase, maintaining constant voltage.
Steps and precautions for physically mounting the charger.
Guidance on selecting the correct cable cross-section based on model and length.
Instructions and warnings for connecting the charger to the battery and system.
Basic installation variant for 12 V or 24 V batteries.
Variant for vehicles without control unit or with a split charge relay.
Variant for vehicles with control unit already installed.
Variant for 24 V system without control unit or with split charge relay.
Procedure for setting the DIP switch for standard or smart alternator.
Instructions for selecting the charging program based on battery type.
Table detailing DIP switch settings for various battery charging curves.
Configuration for activating silent mode to reduce fan or alarm noise.
DIP switch settings for enabling or disabling silent mode.
Procedure to set the input current limit for the charger.
DIP switch settings for limiting input current based on model.
Procedure to set the output current limit for charging different battery types.
DIP switch settings for selecting output current limits for various models.
Steps to perform a system operation check, including battery voltage and current verification.
