Neat Bar Generation 2 - Page 4

Neat Bar
Neat Bar comes with
everything you need to get
started, including cables,
wall mount, table stand and
snap-on mount.
In the box
Neat Bar: Video conferencing device
HDMI cable: 6.5t (2m)
Ethernet cable: 9.8t (3m)
Power cord: 9.8t (3m)
Mount adapter, wall mount, table
stand and snap-on mount
Screws for mounting to the wall are not included. Mounting on a wall should only be performed
by qualified personnel in line with applicable facility and state regulations. The wall and the
mounting equipment must safely withstand the load of the product.
Neat Bar
Gen 2
Mount
adapter
Table
stand
Screen
mount
Sold separately
Wall
mount
Slide the selected
bracket onto the
mount adapter
and secure with
the hex wrench.
Screen mount sold separately
4 × M screw (0.94 in / 24 mm) for VESA mount
4 × M screw (0.94 in / 24 mm) for VESA mount
2 × spacer (to secure parallel TV mount)
1 × 2 mm hex key for the mount adapter
1 × 5 mm hex key for the screen mount
1 additional screw bag for dual screen setup
4 × M screw (0.94 in / 24 mm) for VESA mount
4 × M screw (0.94 in / 24 mm) for VESA mount
4 × spacer (to secure alignment of all screens)
Snap-on
mount