Neat Bar Generation 2 - Additional Product Information

Setup & connectivity
Setup
Use the provided cables to set up Neat Bar.
Connect the cables according to the illustration.
Cables marked are included. Cables marked
are optional and not required for basic use of
the system.
Requirements for
a complete setup
Display
Internet connection
Video service
Environmental Requirements
Ambient operating temperature:
32° to 95° F (0° - 35° C)
Storage temperature: -4° - 140° F (-20° - 60° C)
Relative humidity: 10% to 90%
Network standby: <W (ater 20 minutes)
Additional Product
Information
htps://neat.no/bar-2
Neat Bar (Gen 2) and Neat Pad - User Manual rev03
AC power
9.8t (3m) Cable
USB-C Debug
Ethernet port
16.4t (5m) Cable
Factory reset buton
Power over Ethernet
(PoE)
Power adapter for AC
Factory reset buton
USB-C
HDMI-in for screen sharing
The 16.4t (5m) Ethernet
Cable provided is not to
be used for in-wall
installation. In-wall cable
routing should only be
performed by qualified
personnel using
appropriate equipment.
Security lock slot
WiFi
WiFi
HDMI-out for external screen
6.5t (2m) Cable
Ethernet port
9.8t (3m) Cable
HDMI-out for
external screen