Nebula MH-91 - General Settings Configuration; Invert Movement Settings

6
MENU
Reset
Channels
Display
General
Add DMX
Fans
Run
Yes
No
High
Normal
Low
Auto
Auto1
Auto2
Slave
DMX512
(001~512)
60 close
Bright
Basic
Advanced
Speed
speed4
speed 3
speed
speed 1
speed 0
Info
Edition
ZOOM
Normal
Pos1
Pos2
Default
Default
Yes
No
Effict1
ZOOM
(000~255)
Effict2
(000~255)
【Address】Enter Add DMX to set the DMX Address, which is from (001-512)
【 Reset】In order to rest custom modest to default, select
【 Fans】Enter to select the working mode of fan: is for fast;
is for normal; is for slow ; is for Auto
【Run】Enter to select the operation mode: ; ;
; ;
● 【 】
● 【Reset】
● 【Fans】 【High】
【Normal】 【Low】 【Auto】
● 【Run】 【DMAX512】 【Auto1】
【Auto2】 【Slave】
3.3 GENERAL
7
【 Channels】Enter to select the DMX channel modes: ;
【Display】Enter to select the lighting time of the LCD display panel.
【 】
Enter to see the version of the software.
● 【Person】 【Basic】
【MAIN】.
● 【 Display】
● Dimmer
● 【 Info】
Enter 【Dimmer】 to select dimmer mode and dimmer speed. When
DIMMER is set to 【Off】, then RGBW and MASTER DIMMER are linear.
The Dim 1/2/3/4 are speed modes of the non linear dimmer , 【Dim1】 is
the faster, while Dim4】 is the slowest.
The factory default setting is 【Dim4】.
Select the【ZOOM】range.【POS1】&【POS2】set the small position for the
zoom function.Note that when using DMX to control the fixture, the user will only
be able to access upto the set ZOOM position.It is not possible to adjust beyond
the set position.
●
Use
Dimmer
Tilt
Invert
Pan Normal
Reverse
Normal
Reverse
Normal
Reverse
No
Yes
【 】
● 【 】 【 】 【 】 【Normal】 【Reverse】
● 【 Use】 【Yes】
Invert
Select Pan / Tilt / Dimmer to set or
Enter and set to run the new setting
3.4 INVERT