4. Select the strength according to your preference. Switch be-
tween dierent intensity levels by pressing the Strength control
button according to the condition of your skin. The number of
green LED indicates the strength level. Always start with the
lowest power setting before switching to higher levels. Stop using
the device immediately if your skin develops sensitivity and other
irritations.
5. Put the device on the skin and move slowly within the skincare
area. The process shall be slow and gentle. Make sure that the
head is always touching your skin while you are using the de-
vice.
6. For each area, the skincare session takes 2 minutes. After that,
the device will vibrate to remind you.
7. Continue to the next session for another 2 minutes. The whole
face mini facial should take 10 minutes. After 10 minutes of use,
the device turns o automatically. When it comes to the nose area,
the head may not 100% contact your skin. It is OK because our
smart RF head will only release power to the skin contacted.
8. After the treatment, please wipe the gel from your device, then
continue your skincare routine.
You should feel warm and comfortable as a result of the device.
Move the device slowly as indicated in the illustration below.
The illustration divides the area from your face to your neck into 6
areas. Use 2 minutes for each area, and the device will vibrate and
beep to remind you to move to the next area. Make sure that the head
is always touching your skin while using the device. Be sure to reapply
the smoothing gel to the head gel before moving to the next area.
To Next Page
Loading...
Need help?
General