-125- Toolbox
Alarm clock (press "MENU" key → select “Toolbox” → select “Alarm clock”)
To Set an Alarm
Select the alarm clock to set from Alarm 1 to Alarm 5 and press the Enter key, or press the SK1 (Edit) key.
You can set up to 5 alarm times. You can set a recurring alarm to ring at a specific time on several days of week.
To Do this
1 Set time Set time in 24 hour clock and press the Enter key.
2 Set repeat setting Select one of the following cycles and press the Enter
key: Do not repeat or Weekly.
Do not repeat indicates the alarm is non-recurring.
Weekly is used to set days of week. Select one or
more days using the Enter key.
Note : If you Disable the alarm entry when Weekly
is selected, the alarm entry will put in the
Enable status after the set alarm time elapse
without making the alarm go off. See Enable
the set alarm below.
3 Enter pop-up
contents
Enter contents (up to 32 single-byte characters) to be
displayed in the pop-up window on the set time
screen and press the Enter key.
4 Set clock alarm tune Select the tune you want and press the Enter key.
You can hear the tone by selecting the tone name and
pressing the SK1 (Play) key.
5 Set clock alarm
volume
Select the volume you want and press the Enter key.
6 Set clock alarm
vibration and snooze
Place/remove a check in Vibration and in Snooze
using the Enter key.
When the snooze is set on, once the alarm goes off,
sound and vibration occurs at five minutes intervals
up to three times, unless you stop the snooze function
or stop the alarm clock.
20:28
To Next Page
Loading...
