MG-SIP Page 44 of 75 5/8/2009
• When DisplayName (=0) is selected:
• When Remote-Party-ID (=1) is selected:
Note: Be sure not to enter a blank character to the end of the Dummy string characters (with the Copy and Paste
features of your personal computer), and be careful not to mistype a character.
• When RFC3323/3325 (=2) is selected:
7.5.3.29 SETΔREGISTRATION_PORT_NO
This command is used to specify the UDP port number that receives the registration packets. Pressing the Enter key
can skip the item. In this case, default values are assigned automatically. To make this assignment effective, it is
required to execute the “REBOOT” command to restart the MG-SIP16.
7.5.3.30 SETΔREG_INTERVAL
This command is used to assign the retry waiting time when failed to register, due to the error-response or no answer
from the server when Register packet was sent to SIP server from MG(SIP). Pressing the Enter key can skip the item.
In this case, default values are assigned automatically. To make this assignment effective, it is required to execute
the “REBOOT” command to restart the MG-SIP16.
To Next Page