English−42
COLOR
COLOR Menu
Color Control System Color presets are available for adjusting color settings.
1, 2, 3, 4, 5 Increases or decreases the [RED], [GREEN] or [BLUE] color depending upon which is selected.
The change in color will appear on screen and the direction (increase or decrease) will be shown by the
bars. sRGB (color preset mode [4]) dramatically improves the color fidelity in the desktop environment by
a single standard RGB color space. With this color-supported environment, the operator could easily and
confidently communicate color without further color management overhead in most common situations.
NATIVE The LCD panel’s original colors that cannot be adjusted.
L/B (LOW BLUE LIGHT) Reduces blue light emitted from monitor. This item cannot be adjusted.
NOTE: You can directly change to [L/B] (LOW BLUE LIGHT) mode by touching the INPUT key for
3 seconds or more. For changing to other settings from [L/B] mode, touch the MENU key to show
OSD menu and enter Color Control System.
When [L/B] is selected in Color Control System, [CONTRAST] and [DV MODE] are disabled.
DICOM SIM. The white point color temperature and the gamma curve are set to a DICOM simulation. This item cannot
be adjusted.
PROGRAMMABLE The gamma curve is adjustable through application software.
NOTE: When [MOVIE], [GAMING] or [PHOTO] is selected as the [DV MODE], [NATIVE] is selected
automatically and cannot be changed.
TOOLS
TOOLS Menu
VOLUME Controls the volume of the speakers or headphones.
To mute the speaker output touch the ECO/RESET key.
SOUND INPUT
HDMI, DisplayPort, USB-C inputs only
Selects the sound input source.
VIDEO DETECT Selects the method of video detection when more than one video input is connected.
FIRST When the current video input signal is not present, the monitor searches for a video signal from the other
video input ports. If the video signal is present in another port, the monitor switches the video source
input to the detected video source automatically. The monitor will not look for other video signals while the
current video source is present.
NONE Video input signal detection is not enabled.
DP OUT MULTISTREAM Selects the DisplayPort mode.
NOTE: When the monitor has no image, refer to “Multiple monitors connection using DisplayPort” on
page 23.
CLONE Sets SST (single-stream transport). Default is [CLONE].
AUTO Displays in SST (single-stream transport) or MST (multi-stream transport) mode. [AUTO] should be
selected when using MST (multi-stream transport).*
If multiple monitors are set to [SST], an individual image is displayed at each monitor.
*: MST (multi-stream transport) and SST (single-stream transport) require the computer display adapter supports the feature. Please refer to
the user instructions for the computer or display adapter.
To Next Page
Loading...
Need help?
General