NEC MultiSync V984Q - Connecting USB Devices

English-19
English
Connecting a USB device
USB1: USB downstream port (Type-A).
Connect a USB compatible flash memory or keyboard to Down Stream Port.
USB2: USB upstream port (Type-B).
Connect to a USB compatible computer with a USB cable.
A USB compatible computer connected to USB2 can control the devices connected to USB1.
USB CM1 (2A): Power supply port.
Please refer to the specifications page for power supply information (see pages 72, 73 and 74).
USB CM2
: Service port.
Please do not connect devices.
USB MP: USB downstream port (Type-A).
To use the Media Player function, please use this port.
• Pleasemakesuretheconnectorshapeandorientationis correctly aligned when connecting the USB device or cable.
• DependingontheuseofcomputerBIOS,OSordevice,theUSBfunctionmaynotbeworking.Inthiscase,pleasecheck
user’s manual of your computer or device, or contact your supplier for detailed information.
• BeforeturningoffthemainpowerswitchofthemonitororshuttingdownWindows
®
, please turn off the USB function and
remove the USB cable from the monitor. You may lose data when the computer crashes.
• ItmaytakeafewsecondsuntilthemonitorrecognizestheUSBinput.DonotdisconnecttheUSBcableordisconnect and
reconnect the USB cable before the monitor recognizes the input.
• You can set power supply for USB CM1 (2A) at USB POWER in the OSD menu (see
page 44).
• When you use the USB CM1 (2A) port for power supply, please use a USB cable that supports 2A.
• Do not bind the USB cable. It may cause heat or fire.
• Please refer to the USB in the OSD menu (See
page 44) for the USB setting.
NOTE:
USB CM1 (2A) and USB CM2 are not corresponding port.
Please refer to the connection (See page 17) to connect USB devices to the monitor.