EasyManuals Logo

NEC MultiSync X461UNV Manual

NEC MultiSync X461UNV
43 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
(5/43)
Message format of the Set parameter is as follows,
Refer to section 5.3 Set parameter for more details.
4
Set Parameter reply
The monitor replies with this message for a confirmation of the Set parameter message.
Message format of the Set parameter reply is as follows,
Refer to section 5.4 Set parameter reply for more details.
5
Command
Command message format depends on each command.
Usually, this command message is used for some non-slider controls and some special operations,
such as Save current settings, Get timing report, power control, Schedule, etc. Refer to
section 5.5 Commands message for more details.
6
Command reply
The monitor replies to a query from the controller.
Command reply message format depends on each command.
Refer to section 5.5 Commands message for more details.
4.5 Check code
Check code is the Block Check Code (BCC) between the Header and the End of Message except SOH.
D
n+1
= D
1
XOR D
2
XOR D
3
XOR ,,, D
n
XOR: Exclusive OR
OP code
page
OP code Set Value
STX
Hi
Lo
Hi
Lo
MSB
LSB
ETX
Result
OP code
page
OP code
Type Max value
Requested setting
Value
ETX
STX
Hi Lo
Hi
Lo
Hi
Lo
Hi
Lo
MSB
LSB MSB LSB
Header
Message
Check code
Delimiter
2
7
2
6
2
5
2
4
2
3
2
2
2
1
2
0
SOH D
0
Reserved D
1
Destination D
2
Source D
3
Type D
4
Length(H) D
5
Length(L) D
6
STX D
7
Data D
8
| |
| |
ETX D
n
Check code D
n+1
P P P P P P P P

Other manuals for NEC MultiSync X461UNV

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NEC MultiSync X461UNV and is the answer not in the manual?

NEC MultiSync X461UNV Specifications

General IconGeneral
BrandNEC
ModelMultiSync X461UNV
CategoryMonitor
LanguageEnglish

Related product manuals