83
5 Use the CURSOR or button to select either “ACTIVE” or
“INACTIVE” and press ENTER.
Items to select
• INACTIVE. Displays the input source after the projector is
turned on.
• ACTIVE .... Activates the warm-up program after the projector
is turned on. The ALL WHITE test pattern will be
displayed. You can select a warm-up time from the
WARM-UP TIME menu.
NOTE: To interrupt and cancel the warm-up cycle, press the
END button.
6 To complete, press the END button.
• Whenever the END button is pressed, the menus will sequence
in this order:
“OPTION” menu → “ADJUST” menu → Source screen
• If the “RETURN USER MODE?” menu appears, use the
CURSOR or button to select either “YES” or “NO” and
then press ENTER.
Items to select
• YES ......... When you try to enter the ADJUST mode the next
time, you will need to re-enter your passcode.
• NO ........... When you try to enter the ADJUST mode the next
time, you will not need to re-enter your passcode.
RETURN USER MODE?
YES NO
INACTIVE
ACTIVE
WARM-UP MODE
5 MIN
10 MIN
15 MIN
WARM-UP TIME
SETTING
To Next Page
Loading...
Need help?
General