18
• Adjusting Angle of CRTs for the XG110LC/XG135LC
To adjust the angle of the CRTs, remove screws E and loosen screws
C and D.
Now you can move the tube and lens assembly to one of the three
other positions. Then replace screws E and tighten screws C and D.
This process needs to be done for the red and blue CRTs. The green
CRT is never repositioned. Use the table below to select the proper
setting for your screen size.
NOTE: The threaded hole F is drilled lengthwise so you can move the
CRT assembly to any screen size. Adjust the red and blue lens so that
the red or blue beam is aligned with the green beam. After doing this,
adjust the lens focus (see the next page).
Then tighten the screws E.
Metal impression stamp screen size
Range of screen size (diagonal)
60-300
60"-300"
100
100"
120
120"
180
180"
54321 54321
H V
5
4
3
2
1
5
4
3
2
1
H V
5
4
3
2
1
5
4
3
2
1
H V
FFDD
EC CE
PROJECTION CONFIGURATION CHANGE
To Next Page
Loading...
Need help?
General