HOW TO CLEAN THE FILTER
Cleaning the Lint Filter
Cleaning the drain filter
• In the case of a "Pump-Model" drain hose, this filter is situated at the back side of the washer.
• This drain filter is to screen foreign stuffs such as threads, coins, pins, buttons etc ..
• If the drain filter is not cleaned regularly (once every three month), drain problem could
be caused.
1Pull the filter frame upward. 2Turn the lint filter inside
out, wash the lint off
3Return the filter as it was,
and insert the filter frame
1Pull the power
plug out before
cleaning it.
2Turn off the water
supply to the
washer and
Separate the inlet
hose.
3Pull the inlet filter
out.
4Remove the dirt
from the inlet
filter with a brush.
1Drain the remaining
water in the hose.
Put a container under the
2T
urn the cap counterclockwise.
3Pull out the filter
assembly.
4Clean the drain filter. 5Put the filter in along the
guiding prominence of
the case. Please note the
left position of the filter
adjusting the groove to
the guide rib.
6Turn the cap clockwise
Cleaning the water inlet filter
• Clean the filter when water leaks from the water inlet.
with water.
Filter Frame
Lint Filter
filter to collect water .
FILTER
CONTAINER
CAP
CASE
FILTER
CAP
CAP
FILTER
CASE
GUIDE
RIB
SUIT
into the slot.
CAP
tightly.
CAP
To Next Page
Loading...
