THE FUNCTIONS OF THE CONTROL PANEL
• Press this switch to turn the power on or off.
• Used to choose water temperature being supplied.
• As the button is pressed, water temperature will toggle between.
COLD ➝ COLD+HOT ➝ HOT
• In the case of a single valve model, there is no wash temperature
selector function.
• Used to adjust the amount of water according to the size of the
load to be washed.
• As the button is pressed the water level is selected as follows:
MID ➝ HIGH ➝ LOW
• Used to pre-engage time for wash.
• Used for the partial process or the combination of each
cycle (wash, rinse, spin) (See page 10)
• If you want to change wash times, rinse times or spin times, you must
press this button after selecting each cycle by the cycle button.
Also, this button can be used to spin only. (See page 10)
• Used to select the full-automatic program.
• As the button is pressed the program will be selected in the following order:
FUZZY+SOAK➝HEAVY ➝ DELICATE ➝ FUZZY➝ HEAVY+SOAK ➝ SPEEDY
• Operation and temporary stop is repeated as it is pressed.
• When you want to change a course during operation;
press the "START/HOLD" button ➝ select the program that you want to
change ➝ press the "START/HOLD" button again.
DELAY
HOURS
CONTROL CYCLE
DELICATE
PROGRAM
DELAY
CYCLE
CONTROL
PROGRAM
To Next Page
Loading...
