Need help?Do you have a question about the NEC Pinwriter P7 and is the answer not in the manual?
General| Type | Dot Matrix Printer |
|---|---|
| Print Method | Impact Dot Matrix |
| Print Resolution | 360 x 360 dpi |
| Interface | Parallel, Serial |
| Number of Pins | 24 |
| Print Width | Up to 13.6 inches |
| Paper Handling | Continuous paper |
| Emulation | IBM Proprinter |
| Weight | Approx. 22 lbs |
| Noise Level | 55 dB |
Details the printing speeds in cps for draft and letter quality modes.
Specifies noise levels in dBA for regular and quiet modes.
Describes the impact 24-wire print head specifications including life and diameter.
Outlines vertical line spacing options in lines per inch and programmable settings.
Lists input buffer sizes for parallel and serial interfaces.
Specifies the printer's graphic resolution in dots per inch (dpi).
Indicates the number of copies the printer can produce with copy control.
Lists supported paper widths for P6 and P7 printers.
Provides Mean Time Between Failures (MTBF) and Mean Time To Repair (MTTR) data.
Lists various certifications and compliance standards the printer meets.
Highlights unique functionalities like operator panel controls and auto paper loading.
Lists the built-in font styles available on the printer.
Details the available character sets including ASCII, IBM, and language-specific sets.
Details the functions of each switch on Main Board SW1 for printer configuration.
Describes the functions of each switch on Main Board SW2 for printer configuration.
Explains the functions of each switch on Main Board SW3 for printer configuration.
Details the switch settings for SW5 on the RS-232 board, related to baud rate.
Explains the switch settings for SW6 on the RS-232 board, for protocol and buffer settings.
Describes the switch settings for SW7 on the RS-232 board, for interface mode selection.
Lists error codes that appear when the printer is initially powered on.
Describes the functions performed by the printer's self-test modes.
Details error codes displayed while the printer is actively operating.
Explains status codes, their meanings, and corrective actions.
Outlines the different font styles and character pitches available for selection.
Guides on selecting and obtaining software drivers for the P6 and P7 printers.
Diagram showing pin assignments for the parallel printer interface.
Diagram illustrating pin assignments for the RS-232 serial interface.
Lists and illustrates the main assemblies and part numbers for the P6 printer.
Lists and illustrates the main assemblies and part numbers for the P7 printer.
Lists components for the printer's chassis, outer shell, and operator interface.
Details parts for the print head movement, ribbon feeding, and carriage assembly.
Lists components for paper handling, including platens, rollers, and guides.
Details motors, drive belts, gears, and related mechanical parts.
Lists components for the P7 printer's chassis, outer shell, and operator interface.
Details parts for the P7 print head movement, ribbon feeding, and carriage assembly.
Lists P7 components for paper handling, including platens, rollers, and guides.
Details P7 motors, drive belts, gears, and related mechanical parts.
Details device control codes like DC1, DC2, DC3, DC4 for printer state management.
Covers essential control codes such as Form Feed, Line Feed, and Tabs.
Explains codes for selecting fonts, line spacing, and print modes.
Lists more advanced ESC sequences for specific printer functions and modes.
Details codes for graphics modes, character sets, and formatting controls.
Covers codes for setting vertical and horizontal tabs, margins, and line spacing.
To Next Page