NEC Versa LX - Checking;Setting System Parameters

2-14 System Configuration and Setup
Checking/Setting System Parameters
See the following table for a list of parameters, their factory default settings, and
alternate settings. A description of each setting follows the table.
To reset all parameters to the default settings, select Auto Configuration with
Defaults from the BIOS Setup Main Menu and press Y and Enter.
BIOS Setup Parameters
Parameter Default Setting Alternate Setting(s)
Standard CMOS Setup
System Date mm/dd/yyyy
System Memory Auto detect: total memory
shown in MB
Auto detected
System Time hh/mm/ss hh/mm/ss
Diskette Drive A 1.44 MB, 3.5 Not installed/
1.2 MB, 5.25
1.44 MB, 3.5
Diskette Drive B
1
Not installed 1.2 MB, 5.25
1.44 MB, 3.5
Not installed
Internal Auto Not installed
User defined
Auto
CD-ROM
LS-120
VersaBay
1
Auto Not installed
User defined
Auto
CD-ROM
LS-120
DS VersaBay
1
Auto Not installed
User defined
Auto
CD-ROM
LS-120
DS Internal
1
Auto Not installed/User defined
CD-ROM/LS-120
Advanced CMOS Setup
LCD Panel View
Expansion
Off On
Off
PS/2 Port Hot Swap Enabled Disabled
Enabled
Internal Mouse Enabled Disabled
Enabled