System Configuration and Setup 2-27
2. From the display window, select the desired option.
3. Click Launch to initiate the selected option.
4. Follow the on-screen instructions to process the selected option.
For some of the selected options you are prompted to reboot your system.
5. If necessary, click Exit to close the Customize dialog box.
HDPREPEZ Utility
Using the HDPREPEZ utility automatically configures your Versa’s system’s
save-to-file (STF) area on the hard disk drive.
Procedures for using HDPREPEZ for Windows 95 and Windows NT systems
differ. See the instructions appropriate for your system.
Note: For more details about the HDPREPEZ utility,
see the HDPREPEZ.TXT file in the NECUTILS/HDPREP
directory.
Using HDPREPEZ in Windows 95
In Windows 95, run the HDPREPEZ utility if you increase the memory capacity
in your Versa beyond the factory installed base memory.
Follow these steps to run the HDPREPEZ utility.
1. Power off and restart your Versa.
2. At the statement “Starting Windows 95,” press F8.
3. From the Startup menu, select Option 6, “Safe Mode Command Prompt
Only.”
4. Enter MS-DOS. At the c: prompt, type cd \necutils\hdprep and press Enter
to change to the \necutils\hdprep directory.
5. Type HDPREPEZ and press Enter. The utility automatically prepares your
Versa for the newly installed memory.
6. Power off your system and then power on. A file, large enough to
accommodate your system’s memory is created on the hard disk drive.
To Next Page
Loading...
