Disassembly and Reassembly 3-7
Dip Switch
1. Locate the dip switch block. See figure below.
Dip switch location
2. Using a fine-tipped object, change the appropriate switch to the required
setting. See “Switch Settings” for dip switch functions and settings.
CAUTION
Never use a pencil to change switch settings. Residue from
the pencil can damage the system.
Switch Settings
A four-position dip switch is located underneath the keyboard. The following
list identifies each switch setting and its function.
n Switch 1, Password Override Switch — The default setting is “OFF.” If
you forget your password and cannot access the data on your Versa,
change the setting to “ON” and your current password dissolves.
n Switch 2 — Keyboard select; Default is “ON” for U.S. 85 key keyboard.
n Switch 3 — Reserved for factory use; Default is “OFF.”
n Switch 4 — Reserved for factory use; Default is “OFF.”
To Next Page
Loading...
