3-10 Disassembly and Reassembly
LCD Panel Assembly
1. Remove six screws (A) on the back as shown in the following figure.
2. Disconnect the LCD panel cable at P3 on the Main board.
3. Lift the LCD panel from the bottom cover assembly.
Back of system
A – Screws
Bridge Battery, CMOS Battery, CPU Assembly and Speaker Assembly
1. Disconnect the Speaker assembly cable from P23 (A).
2. Lift the left and right speaker from the bottom assembly being careful not to
stretch the cable
3. Disconnect the Bridge battery cable from P11 (D) on the main board.
4. The Bridge battery (E) is held in place by a double-sided tape gently pry up
to remove.
5. Disconnect the CMOS battery cable from P13 on the main board.
6. The CMOS battery (C) is held in place by a double-sided pressure tape
gently pry up to remove.
7. Remove one screw (B) and lift to disconnect the CPU subassembly from the
Main board.
To Next Page
Loading...
