Nedap the PowerRouter - Install Wizard; Internet connection

EN
12
6.2.4 Install Wizard
The install wizard guides you through the setup of the system parameters.
To prevent accidental system parameter changes, the PowerRouter asks you to login (during commissioning the login is skipped).
The last 4 digits of the serial number on the rating label is used for the login code. Use the Up/Down buttons to set each digit and press the
YES button to conrm and go to the next digit until the last digit is set.
The following parameters can be set: Language, Country, Date & Time, Battery settings (Size, Current, Type, Charge, Voat, Vbulk, Low
battery alarm), AC alarm relay.
Install wizard procedure:
1. Enter the service menu
2. Select Install wizard
3. Press YES to enter Install wizard
4. Press YES to continue the wizard
5. Enter login code
6. Press YES to continue the wizard
The table below shows the battery parameters which can be set during the Install wizard or the software installation tool.
Battery settings (right
relay)
Description Default
value
Minimum
value
Maximum
value
Size Capacity of the battery 400 Ah 100 Ah 40000 Ah
Current Maximum battery charge current 100 A 20 A 200 A
Type GEL or WET GEL
Charge* 3 Stage or Fix. oat charge characteristic 3 stage
Voat Charge voltage 26.4 V 26.0 V 28.0 V
Vbulk Charge voltage if 3-stage charge characteristic is set.
Will not be used if xed oat charge characteristic is set
28.8 V when
3-stage is set
28.0 V 30.0 V
Low battery alarm ON: Low battery alarm relay will be activated if battery
voltage falls below set value
22 V 19.0 V 23.0 V
OFF: Low battery alarm relay will be de-activated if battery
voltage rises above set value
24 V 24.0 V 26.0 V
* Select oat charge for UPS use - select 3 stage for cyclic use.
The table below shows the AC alarm relay parameters which can be set during the Install wizard or the software installation tool.
AC alarm relay (left
relay)
Description Default value Minimum
value
Maximum
value
AC low alarm
Minimum difference
between ON and OFF
setting is 15 V
ON: AC alarm relay will be activated if grid voltage below set
value
180 V 225 V
OFF: AC alarm relay will be de-activated if grid voltage
above set value
225 V 230 V
AC high alarm
Minimum difference
between ON and OFF
setting is 15 V
ON: AC alarm relay will be activated if grid voltage above set
value
235 V 254 V
OFF: AC alarm relay will be de-activated if grid voltage
below set value
230 V 235 V
6.2.5 Internet connection
This clause describes a check if your PowerRouter is connected to the internet.
The internet connection test procedure:
1. Enter the service menu
2. Select Internet connection
The display will show information about the internet status like: Internet connection status (ok, error, counting), Last date and time when the
PowerRouter was internet connected, IP number and status about rmware distribution.