Nedap the PowerRouter User Manual

EN
17
Grid-related error codes
Error code on display Error cause User recommended action
D001-S Grid module temperature too high Check ambient temperature of the PowerRouter. Check for
obstructions in the air ow channel.
D002-S An internal bus problem Contact your installer/dealer if this fault occurs frequently
D003-S
D007-S
D007-H
Grid relay failure
D010-S Internal overload
D015-S Internal communication error
D025-H An internal bus problem
D027-H
D028-H Internal supply voltages out of range
D029-S Cold start failed
D011-S Load voltage too low Check grid voltage
D012-S Load voltage too high
D013-H Load short circuit Check load
D023-H Current overload Disconnect excessive loads
D031-H Power overload
System-related error codes
Error code on display Error cause User recommended action
P027-H Internal voltage error Contact your installer/dealer if this fault occurs frequently
P028-H Internal frequency error
P029-H Internal relay error
P089-H Self-use sensor not found
P092-H The PowerRouter is not congured
P098-H Hardware is not supported in software
P081-H Install wizard error Reset the PowerRouter, re-run the Install Wizard

Nedap the PowerRouter Specifications

General

Brand	Nedap
Model	the PowerRouter
Category	Inverter
Language	English